The PC configuration has been changed after your activation. Eliminate the error performing the following solutions.

• Stop the operation and change hardware settings of your pc as when you activated.
• De-activate and then re-activate it.

This error may be shown in the following cases:

• License activation had been performed with LAN cable connected but RasterLink was started with wireless LAN connection.
• License activation had been performed with wireless LAN connection but Raster Link was started with LAN cable connected.
• Computer configuration was changed.
  Example:
  (a) The motherboard in your pc was replaced.
  (b) The pc has been connected with LAN cable under the different environment when
  License Activation was performed.
  (c) The pc has been connected in the different wireless environment when
  License Activation was performed.

In the case above, please try either one of the countermeasures below:

1. Restore the computer to the condition when License Activation was performed before starting Raster Link.
   Change the network connection (LAN cable or wireless LAN)
   Replace the motherboard of your pc to the original one
2. Activate the License again after deactivate it, and then start Raster Link.
   If the computer is not connected to the internet, perform Substitute License activation.
   For License Activation/Deactivation, please refer to RasterLinkPro5 Installation Guide